Fail2Ban (Linux)

Noch in Bearbeitung

Installation

iptables- verhindert das iptables mitinstalliert wird.

sudo apt-get install fail2ban iptables-

Konfiguration

/etc/nftables/fail2ban.conf

Das Verzeichnis /etc/nftables/ existiert nicht und muss erst angelegt werden:

sudo mkdir /etc/nftables/

Danach die Datei

sudo vi /etc/nftables/fail2ban.conf

erstellen und mit folgendem Inhalt befüllen:

#!/usr/sbin/nft -f

# Use ip as fail2ban doesn't support ipv6 yet
table ip fail2ban {
  chain input {
    # Assign a high priority to reject as fast as possible and avoid more complex rule evaluation
    type filter hook input priority 100;
  }
}

Die zuvor erstellte Datei in

sudo vi /etc/nftables.conf

direkt nach flush ruleset inkludieren:

#!/usr/sbin/nft -f

flush ruleset

include "/etc/nftables/fail2ban.conf"

...

Damit die neue Tabelle aktiv wird, muss die Konfiguration nochmals neu geladen werden:

sudo systemctl reload nftables.service

/etc/fail2ban/action.d/nftables-common.local

sudo vi /etc/fail2ban/action.d/nftables-common.local

[Init]
# Definition of the table used
nftables_family = ip
nftables_table  = fail2ban

# Drop packets 
blocktype       = drop

# Remove nftables prefix. Set names are limited to 15 char so we want them all
nftables_set_prefix =

/etc/fail2ban/jail.local

sudo vi /etc/fail2ban/jail.local

[DEFAULT]
# Destination email for action that send you an email
destemail = fail2ban@mydomain.example

# Sender email. Warning: not all actions take this into account. Make sure to test if you rely on this
sender    = fail2ban@mydomain.example

# Default action. Will block user and send you an email with whois content and log lines.
action    = %(action_mwl)s

# configure nftables
banaction = nftables-multiport
chain     = input