Repeater Bridge (DD-WRT)

Die folgende Anleitung wurde getestet mit dem A1 Modem Pirelle PRG AV4202N als Basisrouter und dem Router TP-Link TL-WR841N N300 als Repeater.

Konfiguration

1. Zuerst einen Hard Reset durchführen (optional).
2. auf dem DD-WRT-Router einloggen unter http://192.168.1.1
3. WLAN->Basiseinstellungen öffnen
   1. Physische WLAN Schnittstelle
      1. WLAN-Modus: Repeater Brücke
      2. WLAN-Netzwerk-Modus: Gemischt

 Open the Wireless -> Basic Settings tab

    Physical Interface Section
        Wireless Mode : Repeater Bridge
        Wireless Network Mode : Match Primary Router (Default MIXED)
        Wireless Network Name SSID : Must Match Primary Router EXACTLY including case.
        Wireless Channel : Usually leave at Auto, DD-WRT will figure out the channel
        Wireless SSID Broadcast : Enable (Default)
        Network Configuration : Bridged (Default)
        Save (not apply) 
    Virtual Interfaces Section
        Add
        Wireless Network Name(SSID) : Same as Primary SSID. If you have problems, try a different one.
        Wireless SSID Broadcast : Enable (Default)
        AP Isolation : Disable (Default)
        Network Configuration : Bridged (Default)
        Save (not Apply!) 

Open the Wireless -> Wireless Security tab

    Physical Interface Section
        Security Mode : Must Match Primary Router. Suggest WPA2-AES ONLY
        WPA Algorithms : Must Match Primary Router
        WPA Shared Key : Must Match Primary Router
        Key Renewal Interval (in seconds) : Leave default 
    Virtual Interfaces Section
        Security Mode : Must Match Physical Interface
        WPA Algorithms : Must Match Physical Interface
        WPA Shared Key : Must Match Physical Interface
        Key Renewal Interval (in seconds) : Leave default
        Save (Not Apply!) 

Open the Security -> Firewall tab

    Uncheck all boxes...except Filter Multicast
    Disable SPI firewall (YMMV) 

Open the Setup -> Basic Setup tab

    Connection Type will be: Disabled
    Set STP for Disabled (Default)
    IP Address : 192.168.1.2 (Assuming Primary Router IP is 192.168.1.1)
    Mask : 255.255.255.0
    Gateway: 192.168.1.1 (again assuming Primary Router IP is 192.168.1.1)
    DHCP Server: Disable (Should already be disabled at this point)
    Local DNS: 192.168.1.1 (if IP of Primary Router is 192.168.1.1)
    Assign WAN Port to Switch : Optionally enable this to use the WAN port as another LAN port.
    APPLY Settings 

Reboot the router. 

Links

https://www.dd-wrt.com/wiki/index.php/Repeater_Bridge

Zurück zu DD-WRT